Housing-Coolant Outlet: Installation: Installation-2.7L

Fig 1: Removing/Installing Heater Supply Tube

Courtesy of CHRYSLER LLC

1 - OUTLET CONNECTOR

2 - SCREW (2)

3 - WATER HOUSING OUTLET WITH TUBE

4 - O-RING

1. Inspect heater tube O-ring (4). Replace as necessary.
2. Lubricate O-ring (4) with a silicone type grease such as Mopar® Dielectric Grease.
3. Install the Water housing Outlet with tube (3) by inserting tube in-between cylinder heads. Insert tube into outlet connector (1).
4. Attach Water housing Outlet tube (3) to the retaining clip at rear of engine.
5. Install attaching screws and tighten to 3 N.m (30 in. lbs.).
6. Install radiator. See INSTALLATION .
7. Fill cooling system. See STANDARD PROCEDURE .
8. Operate engine until it reaches normal operating temperature. Check cooling system for correct fluid levels.