Module, Fuel Pump: Removal: Fold-In-Floor

RELEASE FUEL SYSTEM PRESSURE BEFORE SERVICING FUEL SYSTEM COMPONENTS. SERVICE VEHICLES IN WELL VENTILATED AREAS AND AVOID IGNITION SOURCES. NEVER SMOKE WHILE SERVICING THE VEHICLE.

1. Remove fuel filler cap and perform Fuel System Pressure Release procedure. Refer to FUEL SYSTEM PRESSURE RELEASE PROCEDURE .
2. Disconnect negative cable.
3. Drain fuel tank. Refer to DRAINING FUEL TANK .
4. Remove fuel tank. Refer to TANK, FUEL .
5. Use tool #9340 to remove the fuel pump module lock ring. See Fig 1.
   Fig 1: Module Lock Ring NSE

   Courtesy of CHRYSLER LLC

   THE FUEL RESERVOIR OF THE FUEL PUMP MODULE DOES NOT EMPTY OUT WHEN THE TANK IS DRAINED. THE FUEL IN THE RESERVOIR MAY SPILL OUT WHEN THE MODULE IS REMOVED.

6. Remove fuel pump module and O-ring from tank. Discard O-ring.