LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2007 >> Sebring Base, 2.4 K >> Repair and Diagnosis >> External Pages >> Different car >> Section 26 (Electronic Control Modules (Service Information)) >> Module-Heated Seat >> Removal >> Heated Seat Module

Heated Seat Module

WARNING: This page is about a different car, the 2007 Jeep Patriot and 2007 Jeep Compass. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Locating Heated Seat Module
GC0043475Courtesy of CHRYSLER LLC
CAUTION: The Heated Seat Module mounting tab can be damaged during module removal and installation. Use care to properly align tab to prevent binding that could result in tab breakage.
  1. Position the right front seat to the full rearward position.
  2. Disconnect and isolate the battery negative cable.
  3. Disconnect the wire harness connector (4) from the heated seat module (3).
  4. Unsnap the heated seat module retaining tab (2) from the seat pan (1).
  5. Remove the heated seat module (3) from the vehicle.
scientia non olet · About LEMON Manuals