SWITCH, Ignition: Installation: Installation

WARNING: This page is about a different car, the 2009 Dodge Avenger and 2009 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Interlock Cable

Courtesy of CHRYSLER LLC

1 - Ignition Switch Assembly

2 - Shift Interlock Cable

Install shift interlock cable to ignition switch. Refer to Transmission and Transfer Case/Automatic - 40TE/CABLE, Shift Interlock - Installation .

Fig 2: Module Electrical Connector
Courtesy of CHRYSLER LLC
Push ignition switch up into connect electrical connectors.

Fig 3: Housing Bracket
Courtesy of CHRYSLER LLC
Install location "t" on ignition switch into slot on instrument panel.
Pull ignition switch into place.

Fig 4: Switch Locating Pins
Courtesy of CHRYSLER LLC
Make sure that location pins are in place.

Fig 5: Switch Mounting Screws
Courtesy of CHRYSLER LLC
Install two front mounting screws and tighten.

Fig 6: Rear Mounting Screw And Washer
Courtesy of CHRYSLER LLC
Rear mounting screw and washer.

Fig 7: Switch Rear Mounting Screw
Courtesy of CHRYSLER LLC
Install rear mounting screw and washer and tighten.

Fig 8: Cluster Connectors
Courtesy of CHRYSLER LLC
Connect two electrical connectors to the back of the instrument cluster

Fig 9: Cluster Relocated
Courtesy of CHRYSLER LLC
Relocate instrument cluster and install. Refer to Electrical - Instrument Cluster/Instrument Cluster - Installation .

Fig 10: Switch Cover
Courtesy of CHRYSLER LLC
Install instrument cluster bezel. Refer to Body/Instrument Panel/BEZEL, Instrument Cluster - Installation .

Fig 11: Center Stack Bezel
Courtesy of CHRYSLER LLC
Install radio bezel. Refer to Body/Instrument Panel/BEZEL, Instrument Panel - Installation .

Fig 12: Ignition Switch
Courtesy of CHRYSLER LLC
Connect negative battery cable.
Adjust shift interlock if necessary. Refer to Transmission and Transfer Case/Automatic - 40TE/CABLE, Shift Interlock - Adjustments .