LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2007 >> Sebring Base, 2.4 K >> Repair and Diagnosis >> External Pages >> Different car >> Section 159 (Charging System (Service Information)) >> Generator >> Removal >> 3.5L

Section 159 (Charging System (Service Information)): Generator: Removal: 3.5L

WARNING: This page is about a different car, the 2009 Dodge Avenger and 2009 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: 3.5L GENERATOR ELECTRICAL CONNECTOR
GC0120979Courtesy of CHRYSLER LLC
CAUTION: Never force a belt over a pulley rim using a screwdriver. The synthetic fiber of the belt can be damaged.
  1. Disconnect and isolate negative battery cable.
  2. Remove generator drive belt. Refer to Cooling/Accessory Drive/BELT, Serpentine - Removal .
  3. Unsnap plastic protective cover (4) from B+ mounting stud.
  4. Remove B+ terminal mounting nut (3) and B+ terminal (2) at top of generator.
  5. Disconnect field wire electrical connector (1) by pushing on connector tab.
    Fig 2: 3.5L Generator Remove/Install
    GC0120980Courtesy of CHRYSLER LLC
  6. Remove short mounting bolt (3) from generator (1).
  7. Remove long mounting bolt (2) from generator (1).
  8. Remove generator (1) from engine mounting bracket.
scientia non olet · About LEMON Manuals