LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2007 >> Sebring Base, 2.4 K >> Repair and Diagnosis >> External Pages >> Different car >> Section 144 (Electronic Control Modules (Service Information)) >> MODULE, Powertrain Control >> Removal >> 2.7L/3.5L (NGC)

2.7L/3.5L (NGC)

WARNING: This page is about a different car, the 2009 Dodge Avenger and 2009 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing/Installing PCM - 2.7L/3.5L
GC0120942Courtesy of CHRYSLER LLC
CAUTION: Do not disconnect the Powertrain Control Module (PCM) electrical connectors before the ignition key is in the off position and the battery cable disconnected. If these steps are not preformed damage to the PCM may result from a voltage spike.
NOTE: Note radio programs prior to disconnecting the battery.
  1. Disconnect and isolate negative battery cable at battery.
  2. Remove the Air Cleaner Housing.
  3. Disconnect the electrical connectors (2) from PCM.
  4. Remove nut (1) from upper shock tower stud.
  5. Remove bolt (3) from lower shock tower fastener.
  6. Remove the PCM and bracket (4) from vehicle.
    Fig 2: Separating/Attaching PCM At Bracket - 2.7L/3.5L
    GC0120943Courtesy of CHRYSLER LLC
  7. Remove bolts (3) and separate the PCM (2) from bracket (1).
scientia non olet · About LEMON Manuals