Fuel Level Sensor - Gas (Non FFV)

Fig 1: View Of Level Card Tab

Courtesy of CHRYSLER LLC

Remove fuel pump module, see INSTALLATION .

Fig 2: View Of Sender Card Electrical Connector

Courtesy of CHRYSLER LLC

1. Depress retaining tab and remove the fuel pump/level sensor connector from the bottom of the fuel pump module electrical connector.
2. Pull off locking wedge.
3. Using a small screwdriver lift locking finger away from terminal and push level sensor and ground terminals out of connector.
   Fig 3: Identifying Level Card (Removed)

   Courtesy of CHRYSLER LLC
4. Slide level sensor out of installation channel in module.