LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2007 >> Sebring Base, 2.4 K >> Repair and Diagnosis >> Engine Mechanical >> Exhaust System >> Converter-Catalytic >> Removal >> Removal-Rear 2.7L

Removal-Rear 2.7L

Fig 1: View Of Catalytic Converter - Rear 2.7L
GC0031030Courtesy of CHRYSLER LLC
1 - NUT
2 - HEAT SHIELD
3 - CATALYTIC CONVERTER - REAR
4 - STUD
5 - GASKET
WARNING: The normal operating temperature of the exhaust system is very high. Therefore, never attempt to service any part of the exhaust system until it is cooled. Special care should be taken when working near the catalytic converter. The temperature of the converter rises to a high level after a short period of engine operation time.
  1. Disconnect negative battery cable.
  2. Raise vehicle on hoist.
  3. Remove entire exhaust system from vehicle. See REMOVAL .
  4. Remove exhaust cross-under pipe. See REMOVAL .
  5. Disconnect upstream oxygen sensor.
  6. Remove nuts attaching converter to exhaust manifold.
  7. Remove exhaust manifold heat shield.
  8. Remove catalytic converter.
  9. Remove and discard gasket.
scientia non olet · About LEMON Manuals