Standard Procedure: Cooling-Filling

Remove pressure cap and fill system, using a 50/50 mix of Mopar® Antifreeze/Coolant, 5 Year/100,000 Mile Formula and distilled water. See DESCRIPTION .

Continue filling system until full. Be careful not to spill coolant on drive belts or the generator.  For cooling system capacity, refer to SPECIFICATIONS .

Fill coolant pressure container to at least the MAX mark with 50/50 solution. It may be necessary to add coolant to the coolant pressure container after three or four warm up/cool down cycles to maintain coolant level between the MAX and MIN mark. This will allow trapped air to be removed from the system.