Right Multi-Function Switch
To perform the switch continuity/resistance test, the right multi-function switch must be removed. See REMOVAL .
Using an ohmmeter, check the right multi-function switch continuity and resistances at the switch terminals as shown in the RIGHT MULTI-FUNCTION SWITCH CONTINUITY/RESISTANCE TEST TABLE .
RIGHT MULTI-FUNCTION SWITCH CONTINUITY/RESISTANCE TEST TABLE
| FRONT WIPER/WASHER SWITCH | |||
| SWITCH POSITION | CONTINUITY BETWEEN | RESISTANCE BETWEEN | RESISTANCE |
| Off | - | Pins 7 & 8 | 4286-4379 Ω |
| Intermittent Wipe 1 | - | Pins 7 & 8 | 1445-1480 Ω |
| Intermittent Wipe 2 | - | Pins 7 & 8 | 847-870 Ω |
| Intermittent Wipe 3 | - | Pins 7 & 8 | 556-573 Ω |
| Intermittent Wipe 4 | - | Pins 7 & 8 | 367-380 Ω |
| Intermittent Wipe 5 | - | Pins 7 & 8 | 218-229 Ω |
| Low Speed | - | Pins 7 & 8 | 99-106 Ω |
| High Speed | Pins 7 & 9 | Pins 7 & 8 | 99-106 Ω |
| Mist | - | Pins 7 & 8 | 49-56 Ω |
| Wash | Pins 1 & 3 | - | - |
| REAR WIPER/WASHER SWITCH | |||
| Off | - | - | - |
| Delay | Pins 1 & 6 | - | - |
| On | Pins 1 & 5 | - | - |
| Wash | Pins 1 & 5 & 6 & 2 | - | - |
If the right multi-function switch fails any of the continuity or resistance tests, replace the faulty right multi-function switch as required. See REMOVAL .