LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2007 >> Pacifica Base, 3.8 L >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 3.8L Engine (Service Information) >> Engine Mounting >> Mount-Right >> Removal >> Right Mount

Right Mount

  1. Disconnect the negative battery cable.
  2. Raise vehicle on hoist.
    Fig 1: Right Engine Mount Heat Shield
    GC0002174Courtesy of CHRYSLER LLC
    1 - CRANKSHAFT SENSOR
    2 - BRACKET
    3 - HEAT SHIELD
    4 - EXHAUST
  3. Remove the right mount heat shield. See Fig 1.
  4. Remove the push pins for the in block heater (if equipped), the crankshaft sensor and the oxygen sensor from the engine mount bracket.
  5. Support the engine with a jack stand.
  6. Remove the engine mount bracket fasteners from the transaxle. See Fig 2.
  7. Remove the right engine mount to cradle fastener. See Fig 2.
  8. Loosen the front engine mount to cradle fastener.
  9. Raise and support the engine with the jack stand.
    Fig 2: Right Engine Mount
    GC0002175Courtesy of CHRYSLER LLC
    1 - DRIVE AXLE
    2 - BRACKET
    3 - ENGINE MOUNT
  10. Remove the engine mount. See Fig 2.
  11. Separate the engine mount from bracket.
scientia non olet · About LEMON Manuals