Brake/Transmission Shift Interlock System: Adjustment

Fig 1: Removing/Installing Gearshift Knob

Courtesy of CHRYSLER LLC

1 - SHIFTER KNOB

2 - SET SCREW

1. Loosen set screw (2) and remove knob (1) from shifter handle. See Fig 1.
   Fig 2: Removing/Installing Center Console - Typical

   Courtesy of CHRYSLER LLC

   1 - CENTER CONSOLE

2. Remove the center console assembly (1). See Fig 2.
   Fig 3: Removing/Installing Shifter Bezel

   Courtesy of CHRYSLER LLC

   1 - BEZEL

   2 - SCREW (4)

3. Remove shifter bezel (1). See Fig 3.
4. Adjust interlock cable/system as follows:  Pry up on cable adjuster lock to release and allow cable to "self-adjust". Lock cable adjustment by pressing down on the adjuster lock until bottomed at the cable housing.
5. Verify correct system operation. Refer to the appropriate verification procedure.
6. Install shifter bezel (1).
   Fig 4: Removing/Installing Center Console - Typical

   Courtesy of CHRYSLER LLC

   1 - CENTER CONSOLE

7. Install center console assembly (1). See Fig 4.
   Fig 5: Removing/Installing Gearshift Knob

   Courtesy of CHRYSLER LLC

   1 - SHIFTER KNOB

   2 - SET SCREW

8. Install gearshift knob (1) and tighten set screw (2) to 2 N.m (17 in. lbs.) torque. See Fig 5.