Engine & Automatic Transmission Cooling System: Engine: Fan-Radiator: Installation: Installation-2.0/2.4L

Fig 1: Radiator Fan - Mounting

Courtesy of CHRYSLER LLC

1 - RADIATOR FAN SHROUD

2 - SCREWS

3 - SCREWS

1. Install the radiator fan into position on the radiator.
   Fig 2: Cooling Module - 2.4L Turbo

   Courtesy of CHRYSLER LLC

   1 - RADIATOR FAN FASTENERS

   2 - CHARGE AIR COOLER FASTENERS

   3 - RADIATOR FAN CONNECTOR

   4 - CHARGE AIR COOLER

2. Hand start all radiator fan fasteners.
3. Tighten all radiator fan retaining screws (1 and 2) to 6 N.m (55 in. lbs.).
   Fig 3: Radiator Fan Connector - 2.4L Turbo

   Courtesy of CHRYSLER LLC

   1 - RADIATOR FAN CONNECTOR

   2 - RADIATOR DRAINCOCK

4. Connect radiator fan electrical connector (1).
5. Lower vehicle.
   Fig 4: Radiator Inlet Neck - 2.4L Turbo

   Courtesy of CHRYSLER LLC

   1 - FASTENERS

   2 - RADIATOR INLET NECK

6. Turbocharger equipped vehicles:   Inspect radiator inlet neck O-ring. Replace if necessary. Install radiator inlet neck (2). Torque fasteners to 6 N.m (55 in. lbs.).
   Fig 5: Upper Radiator Closure Panel & Center Brace

   Courtesy of CHRYSLER LLC
7. Connect the upper radiator hose to radiator. Align hose and position clamp so it will not interfere with the engine or the hood.
8. Install upper radiator support and closure panel (1) and center brace (2). Refer to INSTALLATION .
9. Install grille. Refer to INSTALLATION .
10. Install battery tray and battery.
11. Connect cables to battery.
12. Fill cooling system, refer to STANDARD PROCEDURE .