LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2007 >> Crossfire Base, 2D Convertible >> Repair and Diagnosis >> Restraints >> Restraints Control Systems >> DTCS B10DF To B10FA >> B10F5-Speed Sensor Status Signal Invalid >> Diagnostic Test

Diagnostic Test

  1. 1) INTERMITTENT CONDITION 
    NOTE: Diagnose any related Controller Antilock Brake (CAB) DTCs before continuing.

    Turn the ignition on.

    With the scan tool, read the ORC DTCs.

    Does the scan tool display this DTC as active? 

    Yes 

    1. Go to step  2).

    No 

    1. The condition that caused this symptom is currently not present. Check for an intermittent condition by inspecting the related wiring harness for chafed, pierced, pinched, and partially broken wires. Also, inspect the related connectors for broken, bent, pushed out, spread, corroded, or contaminated terminals. Repair as necessary.
    2. Perform *AIRBAG VERIFICATION TEST .
  2. 2) WHEEL SPEED SENSOR STATUS SIGNAL CIRCUIT OPEN 

    Turn the ignition off.

    Disconnect the ORC harness connector.

    Disconnect the CAB harness connector.

    Measure the resistance of the Wheel Speed Sensor Status Signal circuit between the ORC harness connector and the CAB harness connector.

    Is the resistance below 5.0 ohms? 

    Yes 

    1. Replace the ORC in accordance with the Service Information.
    2. Perform *AIRBAG VERIFICATION TEST .

    No 

    1. Repair the Wheel Speed Sensor Status Signal circuit for a open.
    2. Perform *AIRBAG VERIFICATION TEST .
scientia non olet · About LEMON Manuals