LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2007 >> Crossfire Base, 2D Convertible >> Repair and Diagnosis >> Restraints >> Restraints Control Systems >> DTCS B10DF To B10FA >> B10EC-Passenger Airbag Disable Switch Circuit 1 Performance [ZH] >> Diagnostic Test

Diagnostic Test

  1. 1) DETERMINE ACTIVE OR STORED DTC 

    Turn the ignition on.

    Ensure the battery is fully charged.

    Does the scan tool display active DTC: B10EC-PASSENGER AIRBAG DISABLE SWITCH CIRCUIT 1 PERFORMANCE [ZH]? 

    Yes 

    WARNING: To avoid serious or fatal injury, turn the ignition off, disconnect the battery and wait two minutes before proceeding.
    WARNING: If the Occupant Restraint Controller (ORC) is dropped at any time, it must be replaced. Failure to take the proper precautions can result in accidental airbag deployment and serious or fatal injury.
    1. Replace the ORC in accordance with the Service Information.

    No 

    1. Go to step  2).
  2. 2) STORED CODE OR INTERMITTENT CONDITION 

    With the scan tool, record and erase all DTC's from all Airbag System Modules.

    If any ACTIVE codes are present they must be resolved before diagnosing any stored codes.

    WARNING: To avoid serious or fatal injury, turn the ignition off, disconnect the battery and wait two minutes before proceeding.

    Using the wiring diagram/schematic as a guide, inspect the wiring and connectors.

    Look for chafed, pierced, pinched, or partially broken wires and broken, bent, pushed out, spread, corroded, or contaminated terminals.

    The following additional checks may assist you in identifying a possible intermittent problem.

    Reconnect any disconnected components and harness connector.

    WARNING: To avoid serious or fatal injury, turn the ignition on, then reconnect the battery.

    With the scan tool monitor active codes as you work through the following steps.

    Wiggle the wiring harness and connectors of the related airbag circuit or component.

    If codes are related to the Driver Airbag circuits, rotate the steering wheel from stop to stop.

    If only stored codes return continue the test until the problem area has been isolated.

    In the previous steps you have attempted to recreate the conditions responsible for setting active DTC in question.

    Are any ACTIVE DTCs present? 

    Yes 

    1. Diagnose appropriate DTC(s).

    No 

    1. No problem found at this time. Erase all codes before returning vehicle to customer.
scientia non olet · About LEMON Manuals