Front Wiper Module
WARNING: This page is about a different car, the 2007 Dodge Sprinter. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
To avoid serious or fatal injury during and following any front wiper system service, be certain that the key is removed from the ignition lock. When the multi-function switch is set to the I (INTERMITTENT or AUTOMATIC) position, the front wipers could move unexpectedly at any time causing injury or damage.
- Carefully position the front wiper module into the back of the engine compartment as a unit.
- Reconnect the vehicle wire harness connector to the bottom of the wiper motor (6).
- Position the front wiper module to the underside of the cowl top panel with both wiper pivot housings inserted through the clearance holes in the panel.
- Install a rubber pad (3), a washer (2) and a nut (1) to secure each pivot housing to the outside of the cowl top panel. Tighten the nuts to 12 N.m (9 ft. lbs.).
- Install and tighten the screw (4) that secures the wiper motor isolator bracket (5) to the cowl top panel bracket. Tighten the screw securely.
- Reinstall the engine air filter housing into the engine compartment and close the hood.
- Reinstall both front wiper arms onto the wiper pivots. See INSTALLATION .
- Reconnect the battery negative cable.