Headlamp Washer System
WARNING: This page is about a different car, the 2007 Dodge Sprinter. However, it is still accessible from the selected car via links, so may be relevant.
The headlamp washer system plumbing consists of a large diameter high pressure rubber hose that is routed from the barbed outlet nipple of the headlamp washer pump/motor unit on the washer reservoir to a tee fitting located near the left frame rail in the left front corner of the engine compartment. The other two barbed nipples of the tee fitting are connected to two short lengths of hose that each terminate at a telescopic headlamp washer nozzle below and behind the two front lamp units.
Washer hose or tube is available for service only as roll stock, which must then be cut to length. The molded plastic washer hose fittings cannot be repaired. If these fittings are ineffective or damaged, they must be replaced.