6814-In Plant Mode Active-Abs/Esp Function Disabled: Testing
WARNING: This page is about a different car, the 2009 Dodge Sprinter. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK FOR A DTC 6814-IN PLANT MODE ACTIVE-ABS/ESP FUNCTION DISABLED NOTE: This DTC must be active for the results of this test to be valid.
- Turn the ignition on.
- With the scan tool, read and record DTCs.
- With the scan tool, read and record Freeze Frame information.
- Perform ECU initialization with drive test. Refer to Perform ABS VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Antilock Brake (ABS) - Standard ProcedureNOTE: Drive test must be performed correctly for ECU to initialize.
- With the scan tool, erase DTCs.
- Start the engine.
- With the scan tool, read and record DTCs.
Does the scan tool display: 6814-IN PLANT MODE ACTIVE-ABS/ESP FUNCTION DISABLED?
Yes
- Go to step 2
No
- Refer to the INTERMITTENT CONDITION diagnostic procedure.
- Refer to the ABS-INTERMITTENT CONDITION TEST. See DTC-Based Diagnostics/MODULE, Antilock Brake (ABS) - Standard Procedure
- IN PLANT DRIVE TEST ACTIVATED BUT NOT RUN
- With scan tool rerun drive test.
WAS DRIVE TEST COMPLETED?
Yes
- Replace the Anti-Lock Brake Module in accordance with the Service Information.
- Perform ABS VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Antilock Brake (ABS) - Standard Procedure .
No
- Rerun drive test.
- With scan tool rerun drive test.