Code Description
WARNING: This page is about a different car, the 2009 Dodge Sprinter. However, it is still accessible from the selected car via links, so may be relevant.
For complete wiring diagrams, refer to SYSTEM WIRING DIAGRAMS .
- When Monitored:
With the ignition on and no APPS No. 1 and APPS No. 2 DTC present.
- Set Condition:
APPS values No. 1 and No. 2 are not coherent. Idle is additionally forced when the brake pedal is pressed or failed. Acceleration rate and Engine output are limited. One trip fault and the code will set within 5 seconds. ETC light is flashing.
| Possible Causes |
|---|
| EXCESSIVE RESISTANCE IN THE 5-VOLT SUPPLY CIRCUIT |
| EXCESSIVE RESISTANCE IN THE 5-VOLT SUPPLY CIRCUIT |
| EXCESSIVE RESISTANCE IN THE SENSOR NO. 1 RETURN CIRCUIT |
| EXCESSIVE RESISTANCE IN THE SENSOR NO. 2 RETURN CIRCUIT |
| EXCESSIVE RESISTANCE IN THE APP SENSOR NO. 1 SIGNAL CIRCUIT |
| EXCESSIVE RESISTANCE IN THE APP SENSOR NO. 2 SIGNAL CIRCUIT |
| APP SENSOR |
| ECM |
Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. Refer to DTC-Based Diagnostics/MODULE, Engine Control (ECM) - Standard Procedure .