Diagnostic Test

WARNING: This page is about a different car, the 2009 Dodge Sprinter. However, it is still accessible from the selected car via links, so may be relevant.

TEST FOR INTERMITTENT CONDITION
1. With the scan tool, record and erase DTCs
2. Operate the Passenger Window Motor in both directions several times.
3. Cycle the ignition from on to off.
4. Turn the ignition on.
5. With the scan tool, read DTCs.
  Does the scan tool display 90A8-PASSENGER WINDOW CONTROL CIRCUIT - HIGH TEMPERATURE OPERATION?
  
  Yes
  - Go to step 2
  No
  - The conditions that caused this code to set are not present at this time. Check for any binding conditions in the window track and using the SYSTEM WIRING DIAGRAMS as a guide, inspect the wiring and connectors.
  - Perform the BODY VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Body Control (BCM) - Standard Procedure .
WINDOW MOTOR
1. Remove the inner door trim panel.
2. Check for any binding conditions in the regulator and track.
  Was any binding conditions found?
  
  Yes
  - Repair or replace the cause of the binding condition.
  - Perform the BODY VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Body Control (BCM) - Standard Procedure .
  No
  - Replace the Window Motor in accordance with the Service Information.
  - Perform the BODY VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Body Control (BCM) - Standard Procedure .