Diagnostic Test

WARNING: This page is about a different car, the 2007 Dodge Sprinter. However, it is still accessible from the selected car via links, so may be relevant.

1) TEST FOR INTERMITTENT CONDITION
With the scan tool, record and erase DTC's

Turn the ignition on and activate the Speed Control.

With the scan tool, read DTC's.

Does the scan tool display this DTC as active?

Yes
1. Go To 2).
No
1. The condition that caused this symptom is currently not present. Check for an intermittent condition by inspecting the related wiring harness for chafed, pierced, pinched, and partially broken wires. Also, inspect the related connectors for broken, bent, pushed out, spread, corroded, or contaminated terminals. Repair as necessary.
2. Perform BODY VERIFICATION TEST - VER 1 .
2) INSPECT FOR AN OBJECT HOLDING CRUISE CONTROL PUSH-BUTTON IN ACTUATED POSITION
Inspect the Cruise Control push-button for anything that would cause the Cruise Control push-button to stay actuated.

Is anything present that would cause the Cruise Control push-button to stay actuated?

Yes
1. Repair as necessary.
2. Perform BODY VERIFICATION TEST - VER 1 .
No
1. Go To 3).
3) CHECK CHANGE OF ENGINE SPEED SIGNAL SETTINGS
With the scan tool, check Change of Engine Speed signal settings.

Are the signal settings valid and the parameters set?

Yes
1. Replace the Programmable Special Module (PSM) in accordance with the service information.
2. Perform BODY VERIFICATION TEST - VER 1 .
No
1. Go To 4).
4) PROGRAMMABLE SPECIAL MODULE
Using the scan tool, perform Programmable Special Module (PSM) Reset ECU and Load Coding for vehicle application.

Cycle the ignition on and off three times, turn the ignition on.

Activate the Speed Control.

With the scan tool, read DTC's.

Does the scan tool display this DTC as active?

Yes
1. Replace the Programmable Special Module (PSM) in accordance with the service information.
2. Perform BODY VERIFICATION TEST - VER 1 .
No
1. Test Complete.