LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2007 >> Crossfire Base, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 141 (Electronic Control Modules (Service Information)) >> RECEIVER, Wireless Ignition Node >> Standard Procedure >> Module Programming >> Programming Ignition Keys To The Win

Programming Ignition Keys To The Win

WARNING: This page is about a different car, the 2009 Dodge Sprinter. However, it is still accessible from the selected car via links, so may be relevant.

Each FOBIK has a unique ID code that is assigned at the time the key is manufactured. When a key is programmed into the WIN, the module learns the transponder ID code and the transponder acquires the unique Secret Key ID code from the WIN.

CAUTION: Read all notes and cautions for programming procedures.
  1. Connect a battery charger to the vehicle.
  2. Connect the scan tool.
  3. Have a unique vehicle PIN readily available before running the routine.
  4. Ignition key should be in RUN position.
  5. Select "ECU View".
  6. Select "WIN Wireless Control".
  7. Select "Miscellaneous Functions."
  8. Select "Program Ignition Keys or Key FOBs", Start
  9. Enter the PIN when prompted.
  10. Verify the correct information.
  11. Cycle ignition key after the successful routine completion.
    NOTE: If the original keys do not successfully program to the new WIN after the proper procedures are followed correctly, programming new keys will be necessary.
    NOTE: A maximum of eight keys can be learned by the WIN. Once a key is learned by a WIN, that key has acquired the Secret Key for that WIN and cannot be transferred to any other WIN or vehicle.
scientia non olet · About LEMON Manuals