Sentry Key Remote Entry Module: Installation

WARNING: This page is about a different car, the 2006 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/ Installing Sentry Key Remote Entry Module (SKREEM) Or Wireless Control Module (WCM)

Courtesy of DAIMLERCHRYSLER CORP.

When a PCM and the SKREEM/WCM are replaced at the same time, perform the following steps in order (Refer to ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE - PCM/SKREEM PROGRAMMING) and/ or(Refer to ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE - PCM/SKREEM PROGRAMMING) .

Program the new PCM.
Program the new SKREEM/WCM.
Replace all ignition keys and program them to the new SKREEM/WCM.

Position the SKREEM/WCM (3) on the ignition lock housing and install the retaining screw (1).

Fig 2: Locating Sentry Key Remote Entry Module (SKREEM) Or Wireless Control Module (WCM) Housing
Courtesy of DAIMLERCHRYSLER CORP.
Connect the SKREEM/WCM electrical connector (4).
NOTE: On vehicles equipped with the optional Sentry Key Immobilizer System (SKIS), when the SKREEM is replaced with a new unit, a diagnostic scan tool MUST be used to initialize the new SKREEM and to program at least two Sentry Key transponders before the vehicle can be operated (Refer to ELECTRICAL/VEHICLE THEFT SECURITY - STANDARD PROCEDURE - SKIS INITIALIZATION) .
Connect the battery negative cable.