Module-Antilock Brake - MK25E: Removal

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Disconnecting/Connecting Battery Cables

Courtesy of DAIMLERCHRYSLER CORP.

Disconnect negative (-) battery cable (2) from battery post and isolate.

Fig 2: ABM Connector Release Tabs
Courtesy of DAIMLERCHRYSLER CORP.

NOTE: Use this figure in the following step to release the ABM harness connector cover. It shows the location of the release tabs.

Fig 3: Wiring Harness Connector At ABM
Courtesy of DAIMLERCHRYSLER CORP.
Disconnect ABM harness connector from antilock brake module (ABM). To do so:
- Depress tabs on each side of connector cover, then
- Pull outward and upward on lower half of cover until it locks into position pointing straight outward (2). Connector can then be pulled straight outward off ABM (1).
Fig 4: Left Front And Right Front Brake Tubes At ICU
Courtesy of DAIMLERCHRYSLER CORP.
Unclip all brake tubes from two routing clips (1) along upper radiator support.
Unclip right front brake tube (3) from routing clip on bracket below Fuse And Relay Center.

Fig 5: Left Rear And Right Rear Brake Tubes At ICU
Courtesy of DAIMLERCHRYSLER CORP.
Unclip rear brake tubes (1, 2) from routing clip (3) on bracket below Fuse And Relay Center.

Fig 6: ICU Mounting
Courtesy of DAIMLERCHRYSLER CORP.
Lift ICU (1) from mounting grommets (2) and move inboard allowing access to ABM attaching screws. Do not force brake tubes. Move assembly just enough to access mounting screws.

Fig 7: Removing/Installing ABM Mounting Screws
Courtesy of DAIMLERCHRYSLER CORP.
Remove four screws (1) attaching ABM (2) to HCU.

Fig 8: Separation/Installation of ABM & HCU
Courtesy of DAIMLERCHRYSLER CORP.
Slide ABM (1) off HCU (2).