LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2007 >> 300 Base >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Communication Devices >> Electronic Control Modules (Service Information) >> Module - Engine Control >> Standard Procedure >> Pcm/ECM Programming - Diesel >> Section 2 - Additional Pcm / TCM Replacement Procedures

Section 2 - Additional Pcm / TCM Replacement Procedures

NOTE: Find the PCM/TCM Type for the vehicle, read and write down the steps, and then go to the step by step instructions for additional information on how to perform these procedures. See STEP-BY-STEP INSTRUCTIONS .

If an EDC16-U31 PCM was replaced, perform the following additional steps and/or routines: 

  1. PCM Replaced - if WCM equipped
  2. Check PCM VIN - if NOT WCM equipped
  3. Program Variant Code

If an EDC16-C2 PCM was replaced, perform the following additional steps and/or routines: 

  1. PCM Replaced - if WCM equipped
  2. Check PCM VIN - if NOT WCM / SKREEM equipped
  3. IMA Rapid Calibration Test - Only on 06 PT & up
  4. Injector Quantity Adjustment - Only on 06 PT & up

    If an EDC16-CP31 was replaced, perform the following additional steps and/or routines: 

  5. PCM Replaced - if WCM equipped
  6. Check PCM VIN - if NOT WCM equipped
  7. Diesel Particulate Filter (Used) Learning
  8. NOx Catalyst (New) Initialization
  9. Injector Quantity Adjustment
  10. IMA Rapid Calibration Test
  11. Fuel Mean Value Adaptation Initialization
  12. Exhaust Throttle Plate Adaptive Learn Position

    If an EDC16-CP31-2 was replaced, perform the following additional steps and/or routines: 

  13. PCM Replaced - if WCM equipped
  14. Check PCM VIN - if NOT WCM equipped
  15. Injector Quantity Adjustment
  16. Program Variant Code
  17. ECU Replacement With Value Transfer - if the ECU to be replaced is still responsive
  18. ECU Replacement Without Value Transfer - if the ECU to be replaced is NOT responsive
  19. Fuel Mean Value Adaptation Initialization
  20. IMA Rapid Calibration Test
  21. Set Oil Dilution Mass Value

    If a CM849 PCM was replaced, perform the following additional steps and/or routines: 

  22. PCM Replaced - if WCM equipped
  23. Check PCM VIN - if NOT WCM equipped

    If a CM2100 PCM was replaced, perform the following additional steps and/or routines: 

  24. PCM Replaced - if WCM equipped
  25. Check PCM VIN - if NOT WCM equipped
  26. Enable / Disable Vehicle Features - need to enable features
  27. Injector Quantity Adjustment
  28. Reset Regenerative Filter Timers
  29. Mobile DeSoot - NO Minimum Required Soot Load

    If an Aisin TCM was replaced, perform the following additional steps and/or routines: 

  30. Quicklearn

    If an EGS TCM was replaced, perform the following additional steps and/or routines: 

  31. Initialize EGS

    If an NGC4 TCM ONLY was replaced, perform the following additional steps and/or routines: 

  32. Quicklearn

    If an NGC3 TCM ONLY was replaced, perform the following additional steps and/or routines: 

  33. Quicklearn

    If an EATX TCM was replaced, perform the following additional steps and/or routines: 

  34. Quicklearn
scientia non olet · About LEMON Manuals