LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2006 >> Sebring GTC >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Engine & Automatic Transmission Cooling System >> Engine >> Engine Block Heater >> Installation >> Installation - 2.7L

Installation - 2.7L

  1. Thoroughly clean cylinder block heater cavity.
  2. Insert heater assembly into block such that mounting hole is located below heater terminals. See Figure.
  3. Install mounting screw and tighten to 12 N.m (105 in. lb.).
    CAUTION: To prevent damage, the power cord must be secured in its retainer clips, and not positioned so it could contact linkages or exhaust manifolds.
  4. Attach power cord to heater.
  5. Lower vehicle.
scientia non olet · About LEMON Manuals