LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2006 >> Sebring Base, 4D Sedan >> Repair and Diagnosis >> External Pages >> Different car >> Section 111 (Suspension System) >> Wheel Alignment >> Wheel Alignment >> Adjustments >> Adjustments - Dynamic Toe Pattern >> Suspension Component Installation

Suspension Component Installation

WARNING: This page is about a different car, the 2006 Dodge Viper. However, it is still accessible from the selected car via links, so may be relevant.

After toe pattern has been measured and any necessary adjustments made, perform the following:

  1. Install coil-over-shock assemblies. (Refer to SUSPENSION/FRONT/SHOCK - INSTALLATION) , (Refer to SUSPENSION/REAR/SHOCK - INSTALLATION) 
  2. Connect stabilizer bar links to lower control arms. (Refer to SUSPENSION/FRONT/STABILIZER LINK - INSTALLATION) (Refer to SUSPENSION/REAR/STABILIZER LINK - INSTALLATION) 
  3. Verify and adjust wheel alignment toe settings as necessary. (Refer to SUSPENSION/WHEEL ALIGNMENT - STANDARD PROCEDURE) 
  4. Install belly pan. (Refer to BODY/EXTERIOR/BELLY PAN - INSTALLATION)
  5. Road test vehicle to determine if condition is corrected.
scientia non olet · About LEMON Manuals