LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2006 >> Sebring Base, 2D Convertible, 2.7 R >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> HVAC Systems >> Controls >> A/C Pressure Transducer >> Installation

A/C Pressure Transducer: Installation

NOTE: Use only the specified O-ring as it is made of special material for R-134a. Use only refrigerant oil of the type required for the A/C compressor.
  1. Lubricate a new rubber O-ring seal with clean refrigerant oil and install it on the A/C pressure transducer fitting.
  2. Install the A/C pressure transducer onto the A/C discharge line. Hand-tighten the transducer securely.
  3. Connect the wire harness connector to the A/C pressure transducer.
  4. Reconnect the negative battery cable.
scientia non olet · About LEMON Manuals