LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2006 >> Sebring Base, 2D Convertible, 2.7 R >> Repair and Diagnosis >> External Pages >> Different car >> Section 103 (Engine Cooling System) >> Engine >> Water Pump >> Removal

Water Pump: Removal

WARNING: This page is about a different car, the 2006 Dodge Viper. However, it is still accessible from the selected car via links, so may be relevant.
  1. Drain cooling system. (Refer to COOLING/ENGINE - STANDARD PROCEDURE - DRAINING COOLING SYSTEM) .
  2. Disconnect throttle body air inlet hose, remove air cleaner housing assembly. Refer to AIR CLEANER HOUSING .
  3. Remove accessory drive belt. (Refer to COOLING/ACCESSORY DRIVE/DRIVE BELTS - REMOVAL) .
  4. Remove water pump attaching bolts in the reverse order of the torque sequence. See Figure.
  5. Remove water pump. See Fig 1.
  6. Remove and discard the water pump gasket.
Fig 1: Water Pump & Thermostat Housing
GC0036332Courtesy of DAIMLERCHRYSLER CORP.
1 - THERMOSTAT HOUSING
2 - WATER PUMP
scientia non olet · About LEMON Manuals