Front Section
WARNING: This page is about a different car, the 2006 Dodge Viper. However, it is still accessible from the selected car via links, so may be relevant.
- Position the front section of the suction line into the engine compartment.
- Remove the tape or plugs from the suction line fitting and the accumulator port.
- Lubricate a new rubber O-ring seal with clean refrigerant oil and install it on the suction line fitting. Use only the specified O-ring as it is made of a special material for the R-134a system. Use only refrigerant oil of the type recommended for the A/C compressor in the vehicle.
- Connect the front section of the suction line to the accumulator.
- Install the bolt that secures the suction line to the accumulator. Tighten the bolt to 18 N.m (13 ft. lbs.).
- Install the right inner fender splash shield (Refer toFRONT WHEELHOUSE SPLASH SHIELD .
- Install the right front wheel (Refer to TIRES/WHEELS - INSTALLATION) .
- Install the bolts that secure the two suction line brackets to the front of the engine. Tighten the bolts securely.
- Lower the vehicle.
- Remove the tape or plugs from the suction line fitting and the compressor port.
- Lubricate a new rubber O-ring seal with clean refrigerant oil and install it on the suction line fitting. Use only the specified O-ring as it is made of a special material for the R-134a system. Use only refrigerant oil of the type recommended for the A/C compressor in the vehicle.
- Connect the suction line to the A/C compressor.
- Install the bolt that secures the suction line to the A/C compressor. Tighten the bolt 25 N.m (18 ft. lbs.).
- Reconnect the negative battery cable.
- Evacuate the refrigerant system (Refer toREFRIGERANT SYSTEM EVACUATE .
- Charge the refrigerant system (Refer toREFRIGERANT SYSTEM CHARGE .