Idle Air Control Motor: Installation: 3.8L

Fig 1: IAC Motor O-Rings

Courtesy of DAIMLERCHRYSLER CORP.

1 - O-rings

When servicing throttle body components, always reassemble components with new O-rings and seals where applicable. If assembly of component is difficult, a light coat of engine oil may be applied to the O-RINGS ONLY. See Fig 1 to aid assembly.

Fig 2: Throttle Body Components

Courtesy of DAIMLERCHRYSLER CORP.

1 - Purge Line

2 - Throttle Position Sensor

3 - Idle Air Control Motor

The new idle air control motor has a new O-ring installed on it.
Carefully place idle air control motor into throttle body. See Fig 2.
Install mounting screw(s). Tighten mounting screw to 5.5 N.m (49 in. lbs.) torque.
Connect electrical connector to idle air control motor.
Connect negative cable to battery.