2.0L/2.4L Engine

Fig 1: Radiator Fan Shroud - Mounting

Courtesy of DAIMLERCHRYSLER CORP.

1 - RADIATOR FAN SHROUD

2 - SCREWS

3 - SCREWS

Install the radiator fan into position on the radiator.

Fig 2: Cooling Module - 2.4L Turbo

Courtesy of DAIMLERCHRYSLER CORP.

1 - RADIATOR FAN FASTENERS

2 - CHARGE AIR COOLER FASTENERS

3 - RADIATOR FAN CONNECTOR

4 - CHARGE AIR COOLER

Hand start all radiator fan fasteners.
Tighten all radiator fan retaining screws (1, 2) to 6 N.m (55 in. lbs.).

Fig 3: Radiator Fan Connector - 2.4L Turbo
Courtesy of DAIMLERCHRYSLER CORP.

1 - RADIATOR FAN CONNECTOR

2 - RADIATOR DRAINCOCK
Connect radiator fan electrical connector (1). See Fig 3.
Lower vehicle.

Fig 4: Radiator Inlet Neck - 2.4L Turbo
Courtesy of DAIMLERCHRYSLER CORP.

1 - FASTENERS

2 - RADIATOR INLET NECK
Turbocharger equipped vehicles: Inspect radiator inlet neck o-ring. Replace if necessary. Install radiator inlet neck (2). See Fig 4. Torque fasteners to 6 N.m (55 in. lbs.).

Fig 5: Upper Radiator Closure Panel and Center Brace
Courtesy of DAIMLERCHRYSLER CORP.

1 - UPPER RADIATOR CLOSURE PANEL

2 - CENTER BRACE
Connect the upper radiator hose to radiator. Align hose and position clamp so it will not interfere with the engine or the hood.
Install upper radiator closure panel (1) and center brace (2). See Fig 5.(Refer to BODY/EXTERIOR/RADIATOR CLOSURE PANEL - INSTALLATION) .
Install grille, (Refer to BODY/EXTERIOR/GRILLE - INSTALLATION) .
Install battery tray and battery.
Connect cables to battery.
Fill cooling system, (Refer to COOLING/ENGINE/COOLANT - STANDARD PROCEDURE) .