LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2006 >> PT Cruiser Base, 2D Convertible, Automatic >> Repair and Diagnosis >> Restraints >> Restraints Control Systems >> Restraints System (Service Information) >> Front Seat Belt And Retractor >> Installation

Front Seat Belt And Retractor: Installation

WARNING: Front seat belt assemblies must be replaced after a collision.
  1. Place front seat belt retractor into position.
  2. Position lower B-pillar trim panel near B-pillar (Refer to BODY/INTERIOR/B-PILLAR TRIM - INSTALLATION) .
  3. Install the two screws to the webbing mid guide.
  4. Connect electrical connector.
  5. Feed seat belt turning loop and seat belt through trim panel.
  6. Align locating pins on backside of trim panel to mating holes in B-pillar.
  7. Push clips on trim panel into slots in B-pillar.
  8. Install access cover to B-pillar trim.
  9. Install bolt attaching lower seat belt anchor to floor pan kick-up. Tighten bolt to 40 N.m (30 ft. lbs.).
  10. Install bolt attaching turning loop to belt adjuster. Tighten bolt to 40 N.m (30 ft. lbs.).
  11. Move height adjuster to the lowest position.
  12. Install upper B-pillar trim.
  13. Install shoulder belt height control knob.
  14. Install the plastic turning loop cover.
WARNING: Do not connect the battery negative cable (Refer to ELECTRICAL/RESTRAINTS - DIAGNOSIS AND TESTING - AIRBAG SYSTEM)  . Personal injury or death may result if the system test is not performed first.
scientia non olet · About LEMON Manuals