LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2006 >> Crossfire Base, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (3.2L Engine - SRT (Service Information)) >> Oil Level Indicator Tube >> Installation

Oil Level Indicator Tube: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Replace the oil level indicator tube seal and lubricate with engine oil.
    NOTE: The oil level indicator tube must be fully seated or oil leaks can occur.
  2. Position the oil level indicator tube (2) and install it in the crankcase.
  3. Install the bolt (1) in the cylinder head cover and tighten to 10 N.m (89 in. lbs.).
  4. Position the wire harness loom at the oil level indicator tube and fasten with new cable tie (3).
  5. Install the air cleaner housing. (Refer to ENGINE/AIR INTAKE SYSTEM/AIR CLEANER HOUSING - INSTALLATION) .
  6. Start the engine and check for leaks.
scientia non olet · About LEMON Manuals