Rain Sensor Control Module: Installation
WARNING: This page is about a different car, the 2006 Dodge Sprinter. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
To avoid personal injury or death, on vehicles equipped with airbags, disable the supplemental restraint system before attempting any steering wheel, steering column, airbag, seat belt tensioner, or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the supplemental restraint system. Failure to take the proper precautions could result in accidental airbag deployment.
- Position the rain sensor control module to the bracket under the instrument panel above the throttle pedal. See Figure.
- Install and tighten the two screws and nuts that secure the module to the bracket. See Figure.
- Reconnect and lock the wire harness connector to the module connector receptacle.
- Install a new tie wrap to secure the wire harness to the control module.
- Reconnect the battery negative cable.