LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2006 >> Crossfire Base, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Anti-Lock Brake System (Service Information)) >> Lateral Acceleration Sensor >> Removal

Lateral Acceleration Sensor: Removal

WARNING: This page is about a different car, the 2006 Dodge Sprinter. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery.
  2. Move the drivers seat forward and upwards.
    Fig 1: Cover
    GC0036932Courtesy of DAIMLERCHRYSLER CORP.
    1 - SCREWS
    2 - COVER
  3. Remove the cover below the drivers seat. See Fig 1.
  4. Remove the bracket for the control modules and set aside with the control modules. See Fig 2.
    Fig 2: Control Module Bracket
    GC0036933Courtesy of DAIMLERCHRYSLER CORP.
    1 - SEAT FRAME
    2 - BRACKET FOR THE CONTROL MODULES
  5. Remove the screws securing the Yaw rate/lateral Acceleration Sensor. See Fig 3.
    Fig 3: Sensor Remove/Install
    GC0036935Courtesy of DAIMLERCHRYSLER CORP.
    1 - SCREWS
    2 - YAW RATE/LATERAL ACCELERATION SENSOR
  6. Remove the metal cover over the sensor.
  7. Disconnect the electrical connector. See Fig 4.
  8. Remove the Yaw rate/lateral Acceleration Sensor.
Fig 4: Electrical Connector
GC0036934Courtesy of DAIMLERCHRYSLER CORP.
1 - YAW RATE/ATERAL ACCELERATION SENSOR
2 - ELECTRICAL CONNECTOR
scientia non olet · About LEMON Manuals