Stabilizer Bar: Installation

WARNING: This page is about a different car, the 2006 Dodge Sprinter. However, it is still accessible from the selected car via links, so may be relevant.

Install the stabilizer bar to the axle.
Install the stabilizer bar clamps and bracket, center the bar then tighten to 25 N.m (18ft. lbs.) (SRW) or Tighten to 70 N.m (52 ft. lbs.) for (DRW). See Figure and Fig 1.
Install the stabilizer bar to the stabilizer links and tighten to 95 N.m (60 ft. lbs.) See Figure or Fig 1.
Lower the vehicle.

Fig 1: Sway Bar With Dual Rear Wheels (DRW)

Courtesy of DAIMLERCHRYSLER CORP.

1 - STABILIZER LINK

2 - SWAY BRA BOLT

3 - SWAY BAR NUT

4 - SWAY BAR

5 - RUBBER MOUNT

6 - SWAY BAR CLAMP

7 - CLAMP MOUNTING BOLTS