LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2006 >> Crossfire Base, 2D Convertible >> Repair and Diagnosis (Single Page) >> Steering >> Steering Column >> Rack & Pinion Power Steering System >> Linkage >> Drag Link >> Installation >> Notes

Drag Link: Installation: Notes

Fig 1: Removing/Installing Nuts Attaching Drag Link - LHD
GC0032443Courtesy of DAIMLERCHRYSLER CORP.
  1. Clean any grease or debris from the tie rod ends, and the drag link attaching points (1).
  2. Install the drag link and the attaching nuts (1) to the idler arm and pitman arm. Tighten the drag link nuts to 50 N.m (37 ft. lbs.).
  3. Install the tie rod ends into the steering knuckles.
  4. Install the nuts on the tie rod ends. Tighten to 50 N.m (37 ft. lbs.).
  5. Install the steering dampener. Tighten to 40 N.m (29 ft. lbs.).
  6. Adjust the front toe setting on the vehicle. (Refer to SUSPENSION/WHEEL ALIGNMENT - STANDARD PROCEDURE) .
scientia non olet · About LEMON Manuals