Sensor-Water In Fuel: Installation
NOTE:
Remove any dirt and debris around the fuel filter assembly using a suitable solvent or compressed air. Area around the fuel filter assembly must be clean and dry.
- Lubricate the water in fuel (WIF) sensor O rings with clean diesel fuel.
- Insert the WIF sensor into the fuel filter assembly and twist the sensor until the retaining holes align with the retaining bracket on the fuel filter assembly.
- Install the retaining screws. Tighten to 1.5 N.m (13 in. lbs.).
- Connect the WIF wiring harness connector.
- Connect the negative battery cable.
- Start the engine, allow to warm, turn engine off and inspect for leaks.
- Install engine cover.