Steering System (Service Information): Pump: Reservoir: Installation

Fig 1: Removing/Installing Remote Reservoir

Courtesy of DAIMLERCHRYSLER CORP.

1. Install reservoir (2) on coolant bottle (4) by sliding it into guide and allowing it to lock into place.
2. Install return hose (1) on reservoir hose fitting. Install clamp securing hose in place.
3. Install supply hose (3) on reservoir hose fitting. Install clamp securing hose in place.
4. Install air cleaner housing and inlet tube. Refer to appropriate ENGINE - SERVICE INFORMATION article.
   Fig 2: Disconnecting/Connecting Battery Cables

   Courtesy of DAIMLERCHRYSLER CORP.
5. Connect battery negative cable (2) to battery post. It is important that this is performed properly. (Refer to ELECTRICAL/BATTERY SYSTEM - STANDARD PROCEDURE)
6. Fill pump reservoir with fluid and perform pump initial operation procedure. (Refer to STEERING/PUMP - STANDARD PROCEDURE)