LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2006 >> 300 Base, 42RLE/VLP >> Repair and Diagnosis >> Steering >> Power Steering >> Steering System (Service Information) >> Pump >> Pulley >> Removal

Steering System (Service Information): Pump: Pulley: Removal

  1. Remove power steering pump from engine. (Refer to STEERING/PUMP - REMOVAL) 
    Fig 1: Pulling Pulley Using C-4333
    GC0013320Courtesy of DAIMLERCHRYSLER CORP.
    CAUTION: Do not hammer on power steering pump pulley or shaft to remove power steering pump pulley. This will damage pulley and power steering pump.
  2. Mount Puller (2), Special Tool C-4333, on power steering pump pulley (3). Mount Puller (with power steering pump (1)) in a vise as shown in Fig 1; Do not mount pump in vise  . Placing Puller in vise will keep shaft of pump from turning while removing pulley (3) and help keep tension on Puller and pulley hub.
  3. Tighten Puller and remove pulley from shaft of power steering pump.
NOTE: Inspect pulley. Replace if pulley is bent, cracked, or loose.
scientia non olet · About LEMON Manuals