LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2006 >> 300 Base, 42RLE/VLP >> Repair and Diagnosis >> Engine Performance >> Fuel Delivery >> Fuel System >> Fuel Injection - Except Diesel >> Throttle Body >> Installation >> 6.1L

Throttle Body: Installation: 6.1L

Fig 1: THROTTLE BODY O-RING - 6.1L
GC0039510Courtesy of DAIMLERCHRYSLER CORP.
  1. Clean and check condition of throttle body-to-intake manifold o-ring (2).
  2. Clean mating surfaces of throttle body and intake manifold (1).
    Fig 2: THROTTLE BODY R/I- 6.1L
    GC0039509Courtesy of DAIMLERCHRYSLER CORP.
    CAUTION: Do not use spray (carb) cleaners on any part of the throttle body. Do not apply silicone lubricants to any part of the throttle body.
  3. Install throttle body to intake manifold by positioning throttle body to manifold alignment pins.
  4. Install and tighten four mounting bolts (3). Refer to TORQUE .
  5. Install electrical connector (2). To lock connector, slide the red colored tab towards throttle body. Pull firmly on connector to verify a good lock.
  6. Install rubber air hose to throttle body.
  7. A Scan Tool may be used to learn electrical parameters. Go to the Miscellaneous menu, and then select ETC Relearn. If the relearn is not preformed, a Diagnostic Trouble Code (DTC) will be set. If necessary, use a scan tool to erase any Diagnostic Trouble Codes (DTC's) from PCM.
scientia non olet · About LEMON Manuals