Washer Fluid Level Switch: Installation
WARNING: This page is about a different car, the 2006 Dodge Grand Caravan, 2006 Dodge Caravan, and 2006 Chrysler Town & Country. However, it is still accessible from the selected car via links, so may be relevant.
- Use a new grommet when installing a new sensor assembly.
- Assure that the flat of the sensor is aligned under the ridge of the reservoir and that the sensor connector is facing down in the fully seated position. This will allow for proper operation of the sensor float switch.
- Connect the electrical body harness connectors to the fluid level sensor. Slide the red lock on the connector to the closed or locked position.
- Assure that washer hose is properly routed to prevent pinching and possible inoperative washers.
- Connect the left right front wheelhouse splash shield and move aside (Refer to BODY/EXTERIOR/WHEELHOUSE SPLASH SHIELD - INSTALLATION) .
- Install the right front wheel and tire assembly (Refer to TIRES/WHEELS - INSTALLATION) .
- lower vehicle from hoist or jack stands.
- Connect the battery negative cable.
- Verify system operation.