LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2005 >> Sebring Base, 2D Convertible, 2.4 X >> Repair and Diagnosis >> Engine Performance >> System >> Emission Control System - Except Coupe >> Air Injection >> Mass Air Flow Sensor >> Installation

Mass Air Flow Sensor: Installation

  1. Install the rubber mounting to MAF sensor.
  2. Twist the MAF sideways and install to bracket. See Figure.
    Fig 1: Removing/Installing Sensor From Bracket
    GC0031945Courtesy of DAIMLERCHRYSLER CORP.
  3. Connect the electrical connector to MAF.
    Fig 2: Mass Air Flow Sensor
    GC0031944Courtesy of DAIMLERCHRYSLER CORP.
  4. Install the bracket assembly. See Figure.
    Fig 3: Remove/Install Assembly
    GC0031943Courtesy of DAIMLERCHRYSLER CORP.
  5. Install 2 bracket mounting bolts. See Figure.
    Fig 4: Mounting Bracket Bolts
    GC0031941Courtesy of DAIMLERCHRYSLER CORP.
  6. Install the air pump assembly, (Refer to EMISSIONS CONTROL/AIR INJECTION/PUMP - INSTALLATION) .
  7. Connect negative battery cable.
scientia non olet · About LEMON Manuals