LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2005 >> PT Cruiser GT, 2D Convertible, Standard >> Repair and Diagnosis >> Restraints >> Restraints Control Systems >> Passenger Airbag >> Removal >> Deployed Airbag

Deployed Airbag

  1. Open hood.
  2. Disconnect and isolate the battery negative cable.
  3. Roll/fold airbag towards instrument panel.
  4. Close door over folded airbag and tape door closed.
  5. Remove instrument panel top cover (Refer to BODY/INSTRUMENT PANEL/INSTRUMENT PANEL TOP COVER - REMOVAL) .
  6. Open glove box, push in on the box/bin sides and lower to floor.
  7. Remove the right instrument panel end cap.
  8. Remove four passenger airbag cover screws along the bottom end of the airbag cover.
  9. Remove two passenger airbag cover screws along the top edge of the airbag cover.
  10. Remove two nuts retaining passenger airbag to instrument panel assembly inside glove box opening. See Figure.
  11. Lift airbag up until the wire connector is visible and disconnect the wire connector from airbag. Unlock the locking tab and release the connector. See Figure.
  12. Remove passenger airbag from vehicle.
scientia non olet · About LEMON Manuals