Section 76 (Ignition System (Service Information)): Sensor-Knock: Installation: 3.5L

WARNING: This page is about a different car, the 2005 Dodge Magnum and 2005 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: KNOCK SENSOR LOCATION

Courtesy of DAIMLERCHRYSLER CORP.

Install knock sensor. Tighten knock sensor to 20 N.m (15.2 in. lbs.) torque. Over or under tightening effects knock sensor performance, possibly causing improper spark control.

Fig 2: KNOCK SENSOR WIRE ROUTE
Courtesy of DAIMLERCHRYSLER CORP.
Route the knock sensor wire in the proper location.
Install the intake manifold. (Refer to appropriate ENGINE article).

Fig 3: KNOCK SENSOR CONNECTOR
Courtesy of DAIMLERCHRYSLER CORP.
Connect electrical connector. See Fig 3.
Connect negative battery cable.