Section 76 (Ignition System (Service Information)): Sensor-Knock: Installation: 2.7L

WARNING: This page is about a different car, the 2005 Dodge Magnum and 2005 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: KNOCK SENSOR

Courtesy of DAIMLERCHRYSLER CORP.

The sensors screws into the cylinder block, directly below the intake manifold.

Install knock sensor. Tighten knock sensor to 10 N.m (7 ft. lbs.) torque. Over or under tightening effects knock sensor performance resulting in possible improper spark control.
Attach electrical connector to knock sensor.
Install the passenger side cylinder head. (Refer to appropriate ENGINE article).
Install intake manifold. (Refer to appropriate ENGINE article).
connect negative battery cable.