LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2005 >> PT Cruiser Base, 2D Convertible, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Wiper/Washer Systems >> Wiper System & Washer System >> Front Wiper Module >> Removal

Front Wiper Module: Removal

  1. Open hood.
  2. Disconnect and isolate the battery negative cable. See Fig 1.
    Fig 1: Battery Negative Cable - Remove/Install
    GC0020023Courtesy of DAIMLERCHRYSLER CORP.
  3. Using a trim stick (special tool #C-4755) or equivalent, gently pry up on the wiper arm nut cap and remove. See Figure.
  4. Remove wiper arm retaining nut. See Figure.
  5. Remove the arm from the pivot using a rocking motion while the arm is in an over/centered position. See Figure.
  6. Remove the cowl cover. The right side cover overlaps the left side cover, so they both must be removed.
    • Remove the rear engine compartment seal at the cowl.
    • Remove the four push retainers to the right side cowl cover and remove from vehicle.
    • Remove the three push retainers to the left side cowl cover and remove from vehicle.
  7. Disconnect front wiper motor posi-lock harness connector.
  8. Remove three front wiper module mounting bolts and remove module from vehicle. See Fig 2.
Fig 2: Front Wiper Module - Remove/Install
GC0021960Courtesy of DAIMLERCHRYSLER CORP.
NOTE: If replacing the front wiper linkage, the wiper motor must be transferred to the new linkage.
  1. Disconnect drive link from motor crank ball joint.
  2. Remove three bolts to the front wiper motor and separate from linkage.
scientia non olet · About LEMON Manuals