LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2005 >> PT Cruiser Base, 2D Convertible, Automatic >> Repair and Diagnosis >> Electrical >> Charging Systems >> Charging System >> Generator >> Installation >> Installation - 2.0/2.4L

Installation - 2.0/2.4L

  1. Install generator and loose assemble the bolt and nut. See Figure and Figure.
  2. Install and tension the generator belt, refer to COOLING for more information.
  3. Tighten the lower pivot bolt to 54 N.m (40 ft. lbs.)
  4. Install axle shaft, refer to AXLE - FRONT WHEEL DRIVE REAR .
  5. Install lower control arm to steering knuckle, refer to SUSPENSION .
  6. Install the lower ball joint nut and tighten, refer to SUSPENSION .
  7. Install the axle retaining nut and tighten, refer to AXLE - FRONT WHEEL DRIVE REAR .
  8. Install the pencil strut, refer to INTERIOR/EXTERIOR . See Figure.
  9. Install the B+ terminal nut and wire and tighten to 11.3 N.m (100 ins. lbs.). See Figure.
  10. Plug in the field circuit to the generator
  11. Install the accessory drive splash shield. See Figure.
  12. Install the right front wheel, refer to TIRES/WHEELS .
  13. Lower vehicle.
  14. Tighten the T-bolt lock nut and tighten to 54 N.m (40 ft. lbs.) See Figure.
  15. Connect the negative battery cable.
  16. Install the air cleaner lid and connect the inlet air temperature sensor and makeup hose.
  17. Check the transmission fluid.
scientia non olet · About LEMON Manuals