LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2005 >> PT Cruiser Base, 2D Convertible, Automatic >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System >> Front Wheel Speed Sensor >> Removal

Front Wheel Speed Sensor: Removal

  1. Raise the vehicle. (Refer to LUBRICATION & MAINTENANCE/HOISTING - STANDARD PROCEDURE) .
  2. Disconnect the wheel speed sensor cable connector from the wiring harness on the inside of the frame rail above the front suspension crossmember. See Fig 1. The connector has a locking tab which that must be pulled back before the connector release tang can be depressed, releasing the connection.
    Fig 1: Wiring Harness Connector
    GC0022788Courtesy of DAIMLERCHRYSLER CORP.
    1 - RIGHT FRONT WHEEL SPEED SENSOR CONNECTOR
    2 - RIGHT FRONT DRIVESHAFT
    3 - ENGINE OIL FILTER
  3. If the sensor being removed is a left front, unclip the speed sensor cable from the brake tube on the inside of and under the frame rail. See Fig 2.
    Fig 2: Left Sensor Routing Along Brake Tube
    GC0019745Courtesy of DAIMLERCHRYSLER CORP.
    1 - ABS ICU
    2 - BRAKE TUBE
    3 - FRAME RAIL
    4 - ROUTING CLIPS
    5 - WHEEL SPEED SENSOR CABLE
  4. Remove the speed sensor cable grommet from the retaining bracket attached to the brake hose on the outside of the frame rail.
  5. Remove the bolt mounting the wheel speed sensor head to the steering knuckle. See Fig 3.
    Fig 3: Right Front Wheel Speed Sensor (Heat Shield Not Shown)
    GC0019743Courtesy of DAIMLERCHRYSLER CORP.
    1 - RIGHT FRONT WHEEL SPEED SENSOR
    2 - TONE WHEEL
    CAUTION: When removing a wheel speed sensor from the knuckle, do not use pliers on the sensor head. This may damage the sensor head. If the sensor has seized, use a hammer and a punch to tap the edge of the sensor head ear, rocking the sensor side-to-side until free.
  6. Carefully, remove the sensor head and heat shield from the steering knuckle.
  7. Remove the screw securing the wheel speed sensor to the rear of the strut. See Fig 4. Remove the wheel speed sensor.
Fig 4: Ground Strap And ABS Sensor Bracket
GC0019744Courtesy of DAIMLERCHRYSLER CORP.
1 - ABS WHEEL SPEED SENSOR ROUTING BRACKET (IF EQUIPPED)
2 - GROUND STRAP
3 - GROUND STRAP SCREW
4 - ABS SENSOR BRACKET SCREW (IF EQUIPPED)